question about header clearances
#1
Registered Member
Thread Starter
Join Date: Jan 2009
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
question about header clearances
i have a ls vtec swap in my 98 integra ls,(b18b1 block/99 b16 head). im just curious i have a good deal on some hytech replicas. but im not sure if they will clear the oil pan. the current owner has them on a ls, but when i add the b16 head will they rubb or hit the oil pan or even sit to low for clearance ground wise. also what headers will work for this swap, thanks. if it matter im running a stock 2000 gsr exhaust with a electronic cutout. thanks
#2
Re: question about header clearances
i wouldnt think putting a b16 head on would change much header clearance wise. If you have ls bottom end then the ls header should work fine. i could be wrong but im pretty damn sure
#3
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: question about header clearances
Yes, they should be fine. The port spacing (away from the head/block mating surface) is the same from what I remember.
#7
Registered Member
Thread Starter
Join Date: Jan 2009
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
Re: question about header clearances
what specific applications, beause despite how much research ive done everyone has a different anser, is there anyone witha ls-v swap in there car righ tnow that can tell me what application they have on there swap and if it clears the oil pan or rub or anything?
Thread
Thread Starter
Forum
Replies
Last Post