PORT N POLISH???
#1
Registered member
Thread Starter
Join Date: Oct 2008
Location: nova
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
PORT N POLISH???
.. so I’ve done some research on P&P my cars cylinder head, I’ve heard lots of good thing and bad and some that jus say it a waste of $$ and time..I wanted to see if some one here HAS port n polished there cylinder head?? And was it worth it did u feel the deference?? OR …
ANY feed back would help THANKS.
ANY feed back would help THANKS.
#2
Registered Member
Join Date: Jun 2006
Location: Norfolk
Posts: 571
Likes: 0
Received 0 Likes
on
0 Posts
Re: PORT N POLISH???
CFM is key for any engine to make power. Since I see you street race for a living, take some of that mad dough you gotz and hook it up.
Or save some cash, get an air powered rotary grinder, get the largest carbide bit you can find and go to town.
Or save some cash, get an air powered rotary grinder, get the largest carbide bit you can find and go to town.
#3
Slammedxpert
Join Date: Oct 2007
Location: Virginia Beach
Posts: 6,825
Likes: 0
Received 0 Likes
on
0 Posts
Re: PORT N POLISH???
There are other things that you can spend the money on before you P&P the head , to make more power or safer engine mods (tune/fuel system/ect).
Thread
Thread Starter
Forum
Replies
Last Post