ok..how do i put GSR seats in my CRX?
#1
Registered Member
Thread Starter
Join Date: Dec 2006
Posts: 377
Likes: 0
Received 0 Likes
on
0 Posts
ok..how do i put GSR seats in my CRX?
got me some sweet gsr cloths for my rex, and im trying to figure out what is the easiest route to go to get these in my car.
one of my friends suggested buyin rails online that are made for the gsrs to sit in my crx, but of course i couldnt find anything...
so i guess im wonderin if anyone knows any sites where i might be able to find the rails to do this?
Or maybe i should just drill new holes in my car for the seat?
Or modify either my rex rails or gsr rails..
one of my friends suggested buyin rails online that are made for the gsrs to sit in my crx, but of course i couldnt find anything...
so i guess im wonderin if anyone knows any sites where i might be able to find the rails to do this?
Or maybe i should just drill new holes in my car for the seat?
Or modify either my rex rails or gsr rails..
#4
やくざに成りたい
Join Date: Nov 2004
Location: virginia beach
Posts: 2,174
Likes: 0
Received 0 Likes
on
0 Posts
Re: ok..how do i put GSR seats in my CRX?
from experience its not that easy, go ahead and look at them, if it was like my civic it aint gonna happen. i had to weld brackets to make them fit.
#5
posted on da block
Join Date: Jul 2004
Location: 757
Posts: 957
Likes: 0
Received 0 Likes
on
0 Posts
Re: ok..how do i put GSR seats in my CRX?
ahah u stretch the shit outa the rails. bolt one and pull the other one till it bolts. the back right one{center} wont bolt up and the left one is a lil off just get a longer bolt. and some washers. this is how i did it. easier then welding and other stuff. but if its a 88 89 idk i think the holes in the floor diffrent.
#6
Re: ok..how do i put GSR seats in my CRX?
start like this.
both front seat bolts closest to the center console, put those in first.
then go from there.
go to ACE hardware, and get some steel flatbar, or something similar, and start drilling holes, and bolting shit together.
you have to be somewhat mechanically inclined.
if you had an EG theyd bolt right in.
both front seat bolts closest to the center console, put those in first.
then go from there.
go to ACE hardware, and get some steel flatbar, or something similar, and start drilling holes, and bolting shit together.
you have to be somewhat mechanically inclined.
if you had an EG theyd bolt right in.
Thread
Thread Starter
Forum
Replies
Last Post
Beans90CRX
Parts ARCHIVE
129
07-20-2008 03:47 PM