OBX header
#1
Phil for President!
Thread Starter
Join Date: Nov 2002
Location: Va Beach
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
OBX header
i got an OBX header for my ZC swap. i heard that they aren't that good, cuz even tho the bolt holes line up, the port holes don't? argh that sucks. can't i hollow it out some more? i was told that i could, and it would be better for that growl than the raspberry farts
thanks
thanks
#2
I have never seen one so I can't give much advice, but normally a header is made of a fairly thin metal whether its stainless or whatnot. So I don't see it leaving much room for port matching without hurting its strength. You should be able to remove some though.
Thread
Thread Starter
Forum
Replies
Last Post
SHUT UP
Parts ARCHIVE
25
01-02-2008 07:23 PM