obd-o to obd-1 issues
#1
Registered Member
Thread Starter
Join Date: Feb 2010
Location: c ville
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
obd-o to obd-1 issues
i just got a car that was converted from dual point to multi point then obd0 to obd1. my issue is that everything seems to be wired correctly except the 4 wire o2 sensor.the harness is there but not hooked up if someone could please tell me the wire color and pin location that would be great.
#2
Duct tape & Zip Ties
Join Date: May 2009
Location: Austin, TX
Posts: 4,413
Likes: 0
Received 0 Likes
on
0 Posts
Re: obd-o to obd-1 issues
http://fourthgenhatch.net/mpfi.html
search o2 hope that helps. I'll look on my harness too. I think it said c16
edit: holy shit nevermind looking at mine. its to many wires for me. not a electrical junky either. sorry, hope the website helps though.
search o2 hope that helps. I'll look on my harness too. I think it said c16
edit: holy shit nevermind looking at mine. its to many wires for me. not a electrical junky either. sorry, hope the website helps though.
Last edited by SCREECHO; 07-13-2010 at 01:37 PM.
#3
Registered Member
Thread Starter
Join Date: Feb 2010
Location: c ville
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Re: obd-o to obd-1 issues
the car has already been converted mpfi and has correct jumper for the obd1 conversion. I just need to know the pin locations on a obd1 ecu for the o2 sensor and also the corresponding wire colors from the o2 sensor. thanks for the help
#4
Registered Member
Thread Starter
Join Date: Feb 2010
Location: c ville
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Re: obd-o to obd-1 issues
bump
#5
Registered Member
Thread Starter
Join Date: Feb 2010
Location: c ville
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Re: obd-o to obd-1 issues
ok so i have figured out 3 of the wires.The o2 heater wire is pin a6.The signal wire is d14 and the ground is d22.I just need to know where to hook the last wire up which is the power wire i beleive thanks
#6
Registered Member
Thread Starter
Join Date: Feb 2010
Location: c ville
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Re: obd-o to obd-1 issues
problem solved close thread
Thread
Thread Starter
Forum
Replies
Last Post