newbie needs help
#1
Registered Member
Thread Starter
Join Date: Mar 2007
Location: Chesterfield
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
newbie needs help
Just bought 91 dx. Might be buying zc swap but he said i need an unchipped
p28 ecu and wiring harness. Is that all i need for the swap. Also what does a wiring harness run?
p28 ecu and wiring harness. Is that all i need for the swap. Also what does a wiring harness run?
#2
Holy $h!t its gold
Join Date: Jan 2003
Location: norfolk
Posts: 873
Likes: 0
Received 0 Likes
on
0 Posts
Re: newbie needs help
if you run an obd0 zc then you just have to modify your stock harness for the dpfi to mpfi and run a pm6 (si) or pg7 (integra 88-89) or pm7 (zc) ecu. i had a dohc zc hatch and my wifes crx has one too pretty straight forward swap ive done more than a few.
#5
TurboPipingSystems
Join Date: Jul 2003
Location: USDM Land, Va Bch
Posts: 1,483
Likes: 0
Received 0 Likes
on
0 Posts
Re: newbie needs help
Correct^....
to the OP, why were told you need a P28? That's an OBD1 ECU. For a ZC, run what hybrid said... PG7, PM6, or PM7 <--- OBD0 ECU's.
to the OP, why were told you need a P28? That's an OBD1 ECU. For a ZC, run what hybrid said... PG7, PM6, or PM7 <--- OBD0 ECU's.
#7
Holy $h!t its gold
Join Date: Jan 2003
Location: norfolk
Posts: 873
Likes: 0
Received 0 Likes
on
0 Posts
Re: newbie needs help
i did one of those in my brothers ef sedan well z6 head on a sohc zc and ran a pg7 ecu and just ran a vtec controller but with a p28 you have to get a obd0 to obd1 jumper.
Thread
Thread Starter
Forum
Replies
Last Post