SOHC_CriX

so i was doing my swap today for the new d16 vtec in my crx, i was puttin the wiring harness together and i notice that the old wiring harness didnt have the plug for the d16 distriubter. the wiring harness was connected to a d15b2 before the swap, what do i need to do or buy so i can get the right plug for the distibuter???

kwint

Did you convert to mpfi? Are you using a pre made conversion harness?

SOHC_CriX

yes and yes

SOHC_CriX

anybody else know wut i should do???

MajorsEF

your welcome in advanced....u can either repin or cut and splice. find a obd1 eg harness, cut the 2 dizzy plugs off. if u plan to cut and splice leave about 4 inches. then cut your stock one. i spliced mine together and never had a problem. all the wire colors are the same, they all match up. there are 2 white wires, leave these for last. you have to pull back the loom and see which one sits outside the bunch, this will be considered the bigger white wire. ok heres a diagram i made. good luck.

OBD0 OBD1
orange) (orange
white) (white
orange/blue) (orange/blue
white/blue) (white/blue
blue/green) (blue/green
blue/yellow) (blue/yellow
large white) (yellow/green
black/yellow) (black/yellow
blue) (blue