Mini me oil to turbo help?????
#1
Formerly Shinobi....
Thread Starter
Join Date: Dec 2002
Location: www.driftek.net
Posts: 1,077
Likes: 0
Received 0 Likes
on
0 Posts
Mini me oil to turbo help?????
Ok the turbo kit is 99% done but when we went to hook up the fitting for the oil preassure sending switch, all there is is a bolt.....No plug no nothing.....Its a 96 DX block with VTEC head..... Do we just pull that bolt out and put the fitting in there or what? Please help someone.......
#3
Registered Member
Join Date: May 2003
Location: Chesapeake
Posts: 526
Likes: 0
Received 0 Likes
on
0 Posts
Re: Mini me oil to turbo help?????
Should not have found it you mean. You need to take out the oil pressure sending unit and use a t-fitting and line goes to the turbo.
#4
Currently N/A
Join Date: Feb 2003
Location: Virginia Beach
Posts: 339
Likes: 0
Received 0 Likes
on
0 Posts
Re: Mini me oil to turbo help?????
Sounds like you have the wrong "bolt". The oil pressure sending unit is just above and to the left of the oil filter. It's a bitch to get to, but there should be one wire leading into it. You'll need to remove the whole sensor and get a 1/8" NPT "T" from a hardware store so that you can hook up both your sensor and feed line. Be careful not to crossthread the block, it's a pain in the ass from the angle you have to do it. Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
crznx2000
Engine / Exhaust / Drivetrain
0
03-09-2009 04:17 AM
spnamnt
Parts ARCHIVE
11
01-19-2008 08:02 AM