Mazda 2.0L (2009) turns over extremeley hard?
#1
Registered User
Thread Starter
Join Date: Aug 2005
Location: Hayes (Gloucester) VA
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
Mazda 2.0L (2009) turns over extremeley hard?
Replacing a 2009 Mazda3 2.0L motor from a theft recovery. I have a low mileage used engine with 6 month warranty on the engine stand ready to go in. The engine seems extremely tight....can turn over on the flywheel teeth, but it will not easily turn over on the crankshaft pulley via the crank bolt. Should this be a concern or are these engines normally really tight?
There is no mechanical resistance turning on the flywheel, and I will pop off the valve cover and verify cam timing and crank top dead center. Engine has plenty of oil and looks basically brand new.
There is no mechanical resistance turning on the flywheel, and I will pop off the valve cover and verify cam timing and crank top dead center. Engine has plenty of oil and looks basically brand new.
#3
NAZI mod
Join Date: Oct 2008
Location: Virginia Beach
Posts: 1,218,276
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post