jakethesnake110

Im buildin an ls. i just bought b16 pr3 pistons 2 put on my stock ls rods and crank. i was wondering wat all needs 2 be done for the pr3s 2 fit my rods and block?

blackngoldIS

you need a rod heater to put the pistons on those rods.....other than that they should fit either way though just mic them and then hone block to specs.

NasTHatch

are you going ls vtec?

shut the fuck up, you ignorant bastard

blackngoldIS

excuse me?

NasTHatch

do i need to say it in another language?

dirty c

PRESS the old ones off PRESS the new ones on.

NasTHatch

except b16 pistons will not work with stock ls motor UNLESS he is going ls-vtec

blackngoldIS

I just confused as to what I said incorrect?

^exactly...but you use a rod heater to expand the rod on the wrist pin side.

NasTHatch

You sounded Ignorant when you typed it, so therefore i called you an ignorant bastard, and if you remove pistons from one set of rods you don't just have them mic'd, they need to be checked for balance, and the block needs to be honed for the pistons you are installing and not just honed in general, so say all the info and not just half of it

blackngoldIS

Yea I was going to elaborate when the OP posted back....I just didnt feel like I should go into the details of engine machining right off the bat if he didnt know how to search well enough to see if those pistons fit..