are they the same demensions? I'm planning to swap em' out into my Miata, and I hear the USDM ones fit, I was wondering if the JDM one's shared the same specs.

EDIT: or better yet, if someone had either of these seats, could you measure the base width and shoulder width.

 

The JDM ones are wider and a little taller.

 

the irony..

 

I checked these on my JDM recaros, these aren't down to the millimeter or anything but just roughly what they're at. I didn't know if these were the measurements you needed but hopefully it helps, let me know if you needed anything else off of these. I can get you the USDM ones tomorrow if you need.

 

Actually on the Honda tech boards I heard the JDM one's were shorter, height wize. But that's what they say over there... and yes that's about what I was looking for, howercould I get the across demension from the bottom of the seat, where the bolts would fit in. I'm expecteing the flairyou get with the bolsters. But that's exactly what I was looking for jester.

 

i have both and if i can remember tomorrow i will get you some measurement if you still need/want them

 

i don't know about the JDM itr seats but i do know that the recaro SRD will fit in the miata. thats what i'm trying to do in my miata. let me know if you find a set cause i'm looking for one also

 

I was going to recommend he search for the SRD or Speed.

 

SRD = JDM ITR

 

i was told that there was a slight difference. slight difference in a miata might be the difference between fitting and not fitting. If they are the same then thats good also.