Installing RC 550cc Injectors...
#1
VAdriven Sponsor
Thread Starter
Join Date: Jan 2005
Location: NoVA // Springfield
Posts: 894
Likes: 0
Received 0 Likes
on
0 Posts
Installing RC 550cc Injectors...
when installing RC550cc Injectors or larger,
do they just "sit on top" of the rubber o-ring/gasket
on Intake manifold side, or do they actually fit inside??
thanks in adavance for the help
do they just "sit on top" of the rubber o-ring/gasket
on Intake manifold side, or do they actually fit inside??
thanks in adavance for the help
#3
VAdriven Sponsor
Thread Starter
Join Date: Jan 2005
Location: NoVA // Springfield
Posts: 894
Likes: 0
Received 0 Likes
on
0 Posts
Re: Installing RC 550cc Injectors...
#4
I'm worse drugged
Join Date: Mar 2005
Location: Va beach
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Re: Installing RC 550cc Injectors...
try putting the gaskets on the injectors themselves and then tighten down. you can alos put some lube on the outside of the washer, might help.
#5
VAdriven Sponsor
Thread Starter
Join Date: Jan 2005
Location: NoVA // Springfield
Posts: 894
Likes: 0
Received 0 Likes
on
0 Posts
Re: Installing RC 550cc Injectors...
I just talked to one of my buddies w/ RC750's & he says his are just sitting on top..
when he put them in, naturally you would think they should slip inside,
he said he was iffy about the fitment also, but they just sit on top & seal up fine...
anybody actually have or had these injectors & have installed them?
when he put them in, naturally you would think they should slip inside,
he said he was iffy about the fitment also, but they just sit on top & seal up fine...
anybody actually have or had these injectors & have installed them?
#6
Re: Installing RC 550cc Injectors...
Yes, i have run 550 and 750, the lower diameter of the nozzle is slightly larger than OEM. First time i opened mine up with a dremel....BAD IDEA. When i tightened down the rail, i still got fuel leaks.
Just let them sit on top of the o-ring. The tension from the fuel rail will keep them snug.
Just let them sit on top of the o-ring. The tension from the fuel rail will keep them snug.
#7
To old for this shit
Join Date: Apr 2006
Location: F'burg
Posts: 1,146
Likes: 0
Received 0 Likes
on
0 Posts
Re: Installing RC 550cc Injectors...
Paul, had the same issue? Put the Injectors in the Manifold, push in as far as they will go, put the fuel rail on, push on rail and screw the 3 nuts down tight. At first I couldnt get the fuel rail far enough down to reach and bolt in. Just press down hard and thay should go. I ripped an O-ring in the process, so check when your done. Later
#8
VAdriven Sponsor
Thread Starter
Join Date: Jan 2005
Location: NoVA // Springfield
Posts: 894
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
b16crx000
Want to Buy / Trade ARCHIVE
0
12-22-2007 02:55 AM