lil_nino187

Need help deciding which cams should I use for my allmotor h22
It's has stock internals.

VroomVroom

kill it with fire
buy b series
????
profit

bbsIx

fail.

c2status

naw you blaze it more with a h22 h2b si tranny kit. go bisimoto style he runs a h22 motor with a si b-series tranny . but with cams i would go with SKUNK 2 stage 2 cams. or some TODA's

egsir

get some type s cams.. stage two's lobes are too big for a stock head.. youlld worp the head aftera couple months. stage 1 is the way to go if you got stick internals.

b20teggy

^^^ agreed. My friend had type S cams in his h22 and it had decent power.

lil_nino187

But type s cams r supposed to put out like 200 HP rite n Im already makin.
That I want to make like 225 or 230 with cams n cam gears

I Love (.)(.)

I wouldnt even put cams in it. put a nice header, nice exhaust and get a good tune. otherwise id start with the bottom end first as far as a build goes. the bottom ends are for sure the weak link in those motors. you can get some mahl (not sure on exact spelling) pistons for pretty cheap and they are the only pistons for that motor that allow stock sleeves. any other pistons and you will need to sleeve the block. with a sleeved block and a forged rod and piston combo (high compression) you can put any cams in it you want, and will be ultra reliable n/a motor. but with any set of cams you get, you need to upgrade the springs and retainers. bottom line is I dont think you are going to see a very noticeable difference when upgrading to a stage 1 cam, and you wont be able to run a bigger cam with oem pistons if I remember correctly.

lil_nino187

So u would recommend building the bottom end first such
Such as piston rods bearings n shyt like that....wut brand would u recommend for all motor

b20teggy

^^^ Yes start w/ bottom end first and the brand he stated was Mahle.