thesnakejake

hello fellas i am rebuilding my d16a6 for my crx and ive got it all stripped down and getin ready to order my new bearings and piston rings and all that good stuff.. im putin p29 pistons on my stock rods and im using everything else from the d16a6.. crank.. rods.. etc.. the one question i have is where abouts should my bearing clearances be once i put it back together?? help would be greatly appreciated..thank you and have a blessed day =)

Fabrik8

If you're doing a stock rebuild, use the stock bearing specs from the factory manual.

thesnakejake

itll all be stock except the p29 pistons ..

Fabrik8

You should be good to go with the stock bearing clearances then.