crx forced air intake
04-06-2003, 08:37 PM
#1
Boner Jams
Thread Starter
Join Date: Feb 2003
Location: Dirty ass kempsville
Posts: 7,227
Likes: 0
Received 0 Likes
on
0 Posts
crx forced air intake
has anyone on here done a forced air intake from the bumper up to the stock air box, i just put mine back in and put a k&n in it cause im gunna do a sealed piping down to the bumper has anyone done it and know the measurements or am i gunna have to geuss and what did you use for mounts
_
l
l)==
_l ll
ll
ll
===(
_
l
l)==
_l ll
ll
ll
===(
04-07-2003, 06:47 PM
#5
Type-R; Tight Car
Join Date: Feb 2003
Location: Seattle, WA
Posts: 3,429
Likes: 0
Received 0 Likes
on
0 Posts
i just used dryer ducting when i had a crx and put a vent in the inlet it stays cold all the time but then again you will probably be mad efun of since its not chrome ro you could just not care
04-09-2003, 08:10 AM
#7
Team Ultraspeed
Join Date: Nov 2002
Location: Nonya (hint: VaBch)
Posts: 1,148
Likes: 0
Received 0 Likes
on
0 Posts
I've had quite of few people ask this same question...problem is, it is a little hard to describe the set up...and to get it right. The best thing is to just show ya. There will be some cutting of the frame to use the 5" dia set-up I am using now, but nothing drastic.
I've been trying to come up with a doc & pics to just e-mail people when they ask, but time has been holding me back, and so far, it's a one page ordeal.
If you like to see it (it's no big secret), just PM me and I'll give you my number.
I've been trying to come up with a doc & pics to just e-mail people when they ask, but time has been holding me back, and so far, it's a one page ordeal.
If you like to see it (it's no big secret), just PM me and I'll give you my number.
Thread
Thread Starter
Forum
Replies
Last Post