Clutch/Install 96 Teg LS 4 DR
#1
Registered member
Thread Starter
Join Date: Nov 2002
Location: here
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
Clutch/Install 96 Teg LS 4 DR
I have zero experience doing this so I was hoping to get some ideas on who to talk to about getting it done and is there a better alternative to stock for a basic daily driver including better price etc... Thanks for any suggestions!!!!!!!!!!!!!!! Oh yeah, I'm assuming it's best to replace the clutch,pressure plate and throw out bearing???? BTW, the car has about 112k on it so I hope this info helps! thanks again!!
#3
DESTROYS DONUTS !!
Join Date: Nov 2002
Location: the seed has sprouted.
Posts: 13,275
Likes: 0
Received 0 Likes
on
0 Posts
Re: Clutch/Install 96 Teg LS 4 DR
Originally posted by vanish24
I have zero experience doing this
I have zero experience doing this
have fun chief........ ill give you a tip though, get someone to help you guide the tranny back onto the dowel pins, i did mine by myself, and its a pain in the ass.........its truthfully not that hard of a process, its just time consuming, and you have to take alot of shit off, like i said, have fun.............and if you order a new clutch from an aftermarket company you should get a new pilot bearing, throwout bearing, clutch alignment tool and pressure plate with the clutch plate........AND MAKE SURE TO GREASE THE HELL OUT OF THE THROWOUT BEARING, AND THROWOUT FORK.....and resurface the flywheel.......75 ft lbs for the flywheels bolts, and 25 ft lbs for the clutch bolts....call me or chahonda if you want to pay to get it done.........
Thread
Thread Starter
Forum
Replies
Last Post