click but not the cv joint
#1
Registered Member
Thread Starter
Join Date: Apr 2009
Location: Norfolk
Posts: 1,424
Likes: 0
Received 0 Likes
on
0 Posts
click but not the cv joint
i have a 91 ls 4 door integra and yesterday i took out the driverside c.v. axel, cleaned and replaced the boot and it is still click clacking everytime i turn left and right but not doing it in reverse and not doing when i coast while turning or throw it in neutral while im turning.
if anybody has any idea what it might be please i need help its sounds like its getting worse by the week and its really anoying.
HELP
oh yea the center boot/pad in the middle of the axle where is that supposed to sit after fully installed?
if anybody has any idea what it might be please i need help its sounds like its getting worse by the week and its really anoying.
HELP
oh yea the center boot/pad in the middle of the axle where is that supposed to sit after fully installed?
Last edited by twintegra518; 07-06-2009 at 07:38 PM. Reason: another reason
#4
Sorry. Not really.
Join Date: Nov 2005
Location: Fairfax
Posts: 8,283
Likes: 0
Received 0 Likes
on
0 Posts
Re: click but not the cv joint
If the boot has been torn and letting dirt/sand/debris into the joint for months, chances are the joint is too far gone. When an axle boot rips or tears, it must be replaced immediately. If you wait until you hear a clicking until you replace it, a new boot isn't going to help you.
Thread
Thread Starter
Forum
Replies
Last Post