00civicman

i have a 1990 civic hatch i have a prob when im turning left if feels like the right side front wheel is wobbling or something the axel is new and the lug nuts are tight what else could it be im thinking wheel bearing any other suggestions

Fabrik8

Most likely wheel bearing, but it could be a bad bushing or ball joint too.

1rude2l

bent wheel can cause this too.

BigandSlow

Did you just replace the axle? Is the axle nut tightened enough?

00civicman

im goin to check it out tomorrow is there a way to check tha ball joint i was also told the wheels probably need balanced

Hicky

if you grab a hold of you wheel and if can make it "wobble" it in it out vertically, i think thats how you check the ball joint if its bad. Its one way for ball joint, and another for wheel bearing. Fabrik8 might know what im talking about and maybe could re-say it to make more sense.

C16EFSedan

If the balljoint breaks lemme tell you from experience it will practically rip your fender off and your lucky if you dont wreck when it happens

BigandSlow

It's not wheel balance.

To check the ball joint, have the car jacked up from the subframe or unibody or whatever just not from the suspension/lca. Grab the tire top and bottom and shake it, if you feel a looseness in it it's usually a ball joint (although if your axle nut is loose it will do this too so check that first if it's a new axle and somebody just had that nut off.)

Grabbing the tire on the sides and it being loose indicates worn tie rods.

00civicman

i found out wat it was today one of the damn upper strut mounting bolts busted through the top inside the engine bay so now i have to get tha hole welded or somethin thats crazy ive never seen nothin like that happen

burton

anybody have any idea how much it would cost for a shop to replace a bearing?