Red81Z28

I put a jdm b16a in a 91 crx hf and it won't start. turns over and has fire. injectors are getting fuel but i don't know how well they are working. seems to be leaking a little water somewhere around the water pump area. Plugs seem to be wet when i pull em out but i can't smell gas. Maybe it's oil or antifreeze. Any suggestions? Also, i got the swap from someone on here that claims they bought the swap from hmotorsonline.

DOHC crx VTEC

I have a B16a in my crx as well.....If you need help...pm me

Red81Z28

starts with ether!?

DOHC crx VTEC

If you need help.....I may be able to help you out.

729-1135

-Mike

Red81Z28

sees to be head gasket cause there is water in the combustion chamber. anybody know how to take the crank pulley off?

j4k3

your going to need to remove the big bolt in the center then use a gear remover and pry it off. im not positive if its on all hondas but there may be a small piece of metal (rectangular) that you'll have to keep an eye out for, it has to go in when you put it back together or it wont be put on right.

Red81Z28

it took a couple minutes with the impact gun at 140 psi and spraying pb blaster on it.

hi boost 21 psi

you can use a chain wrench to hold the pully still but you will need to get a old peice of belt to wrap around the pully so the chain doesnt mess it up. then use a breaker bar to get the nut loose... its kind of a pain in the ass but it works..