Gr0dy

A buddy of mine wants me to put some subs and an amp in his car. He's got 2 JL W3s (10 inch 2 ohms) and a pyle red elite PLA4180 4 channel amp. Specs for the amp are HERE . I was planning on bridging the amp to get more power, it's 125w rms per channel at 4 ohms so 250 rms x 2 if i bridge it. My only concern is that the subs are 2 ohms. My question is would i be able to bridge it still? If not, can i even use these subs with this amp? If i can how would i have to connect it? Thanks in advance

EDIT:: I found out its only 2 ohm stable in stereo mode, and not in bridged mode. What would be the best way to connect these to get the most power?

Fabrik8

if you want to bridge down to 2 channels, you'll need 4 ohm subs. If you want to keep the 2 ohm subs, you can run 2 channels at 2 ohms each and not use the other 2 channels. Or, you could connect the subs in series for a single 4 ohm load, and bridge 2 channels to that, also not using the other 2 channels.

Gr0dy

alright thanks man

Fabrik8

Tell your buddy to get a beefy set of front components to use the other two amp channels. 125W per channel should do quite nicely.