Cams to use for this setup? HELP!!!
#1
Registered Member
Thread Starter
Join Date: Mar 2008
Location: JDM CITY
Posts: 819
Likes: 0
Received 0 Likes
on
0 Posts
Cams to use for this setup? HELP!!!
I am wondering what cams i should use to make power in my all motor setup which would be best for my setup:
Engine: Ls Vtec Bottom end
Type R Head:
I was told to look into Jun Stage 3 or Toda C or D , Skunk2 Pro 3, or Rocket Motorsport M24X
anyone who has had similar setup please help me find out cams best for this setup
Engine: Ls Vtec Bottom end
- Scat Crank
- JE Rods
- Weisco 13:5:1 pistons
- 85mm Bore Sleeved
Type R Head:
- Ferrea Valves
- Skunk2 Valve springs and retainers
- 5 angle valve job
- Skunk2 Intake Manifold
- 70mm Power Throttle Body
- RMF Headers
- 540cc Injectors
- Type R Tranny with lsd
- Clutchmaster Stage 5 Clutch
I was told to look into Jun Stage 3 or Toda C or D , Skunk2 Pro 3, or Rocket Motorsport M24X
anyone who has had similar setup please help me find out cams best for this setup
#4
Re: Cams to use for this setup? HELP!!!
I am wondering what cams i should use to make power in my all motor setup which would be best for my setup:
Engine: Ls Vtec Bottom end
Type R Head:
I was told to look into Jun Stage 3 or Toda C or D , Skunk2 Pro 3, or Rocket Motorsport M24X
anyone who has had similar setup please help me find out cams best for this setup
Engine: Ls Vtec Bottom end
- Scat Crank
- JE Rods
- Weisco 13:5:1 pistons
- 85mm Bore Sleeved
Type R Head:
- Ferrea Valves
- Skunk2 Valve springs and retainers
- 5 angle valve job
- Skunk2 Intake Manifold
- 70mm Power Throttle Body
- RMF Headers
- 540cc Injectors
- Type R Tranny with lsd
- Clutchmaster Stage 5 Clutch
I was told to look into Jun Stage 3 or Toda C or D , Skunk2 Pro 3, or Rocket Motorsport M24X
anyone who has had similar setup please help me find out cams best for this setup
#9
braap braap
Join Date: Jul 2003
Location: Portsmouth
Posts: 14,535
Likes: 0
Received 0 Likes
on
0 Posts
#10
Re: Cams to use for this setup? HELP!!!
Skunk2 Pro 2's will work very well with your 85x89 13.5:1C/R setup....Just my opinion thought but a ported PerformerX will be a much better manifold than that skunk2 hands down creates much more mid range torque! Setup looks good so far keep us updated on the results.