b16 missfire question
03-27-2010, 08:37 AM
#1
Registered Member
Thread Starter
Join Date: Mar 2010
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
b16 missfire question
today i disconnected my ecu (P30) to check out some pin locations and when i reconnected it, the car started shaking and wouldnt pass 4 grand revs and wouldnt accelerate which was what led me to beleive that it's misfiring any ideas anything would help at this point thanks
03-27-2010, 09:11 AM
#2
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: b16 missfire question
Check the connectors at the ECU.. If all you've done is disconnect and reconnect the ECU connectors, chances are good that you've shoved one of the crimp pins out of the back of the connector shell. That's just about the only thing that would have caused that unless you broke a wire at the connector.
Thread
Thread Starter
Forum
Replies
Last Post