b-series tb on a d-series motor
#1
Registered member
Thread Starter
Join Date: Feb 2009
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
b-series tb on a d-series motor
i was wondering would a b-series tb bolt up to a d-series motor, i know i would probably have to swap out my throttle spring assembly tps and map but i was wondering if it would even bolt up properly
#2
Registered Member
Join Date: Jan 2008
Location: Near Charlottesville
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
Re: b-series tb on a d-series motor
yes it does fit, you might see very minimal gains, but it is better then a d series one.
#6
1.6L's of N/A fury!!
Join Date: Nov 2004
Location: portsmouth, va.
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
Re: b-series tb on a d-series motor
yes it will fit and yes you will notice a gain as well. If you get a B18B Ls TB (which is 60mm) and couple that to a skunk2 intake manifold, you will see a nice gain in topend power.
Thread
Thread Starter
Forum
Replies
Last Post
1990CRXSi
Engine / Exhaust / Drivetrain
5
06-26-2009 11:16 AM
JDMB16CRX
Want to Buy / Trade ARCHIVE
8
08-07-2008 08:13 AM