Any1 do a head swap?
#1
Frinzo
Thread Starter
Join Date: Apr 2003
Location: Hampton/ Va beach
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Any1 do a head swap?
ok i finally got all my parts in for the toy, but i dont now how to do a head swap, from the 22R head to a 20R head, i think its pretty simple but when it comes to the manifuald im lost. Was just wandering if there is any1 on here that has done a cylinder head swap on a toyota truck or could atleast point me to some1 that has.
Thnkx
Thnkx
#2
brake/steer/throttle
Join Date: Nov 2002
Location: sod off you bloody wanker
Posts: 1,542
Likes: 0
Received 0 Likes
on
0 Posts
is this a 22R-E? or just 22R? make sure to have the 20R head checked for warpage. make sure to use new Toyota head bolts or get ARP studs. use a Toyota or HKS headgasket. what carbuer-traitor are you using? you'll get much better results if you do a 32/36 DGEV Weber or a 38/38 DGES rather than a Toyota carb. much better performance too! a nice Doug Thorley header and maybe a few degress from a WEBCAM and an LC Engineering adjustable cam gear will help. this will be a good time to check the condition of your timing chain. check E.L. Prototypes for some upgrades available for your timing chain.
good luck!
good luck!
#3
Frinzo
Thread Starter
Join Date: Apr 2003
Location: Hampton/ Va beach
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
ok this is what i have going on the truck.
-38mm Weber carb
-48mm vavles(intake) and 40mm(exhuast)
-Street Perfomer Cam(lcengineering)
-street performer exhuast(lcengineering)
-intake manufuild(20R)
-20R head for the truck.
-ARP studs
-All new stuff for the cylinder head too..
All this is going on the 22R engine block. Also is there a place localy that I can buy block off plates for the exhuast? That and a 20R water pumper link, goes on top of the manifuald. Any other questions just ask and i can tell you. Thnkx
-38mm Weber carb
-48mm vavles(intake) and 40mm(exhuast)
-Street Perfomer Cam(lcengineering)
-street performer exhuast(lcengineering)
-intake manufuild(20R)
-20R head for the truck.
-ARP studs
-All new stuff for the cylinder head too..
All this is going on the 22R engine block. Also is there a place localy that I can buy block off plates for the exhuast? That and a 20R water pumper link, goes on top of the manifuald. Any other questions just ask and i can tell you. Thnkx
#5
Frinzo
Thread Starter
Join Date: Apr 2003
Location: Hampton/ Va beach
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
its a 38mm downdraft. the exhuast block off plates, the ones that you put aboce the actual exhuast... unless they build the performance heads with them on already?
Thread
Thread Starter
Forum
Replies
Last Post
crxtyper
Parts ARCHIVE
22
01-18-2008 10:21 PM