95 Civic clutch issue
#1
Registered Member
Thread Starter
Join Date: Aug 2011
Location: Chesapeake
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
95 Civic clutch issue
I recently bought a 95 civic hatch and I'm having an issue with the clutch. I don't think the clutch is bad because it's not slipping, but it is loose. When I push the clutch in, it is loose until about halfway down and it's hard to change gears, I couldn't even put it into reverse at all at one point. I had no issues at all and then suddenly this happened with no warning (at least none that I noticed). I've researched some issues and have found that it could be one of a few things. It could be my fluids, master cylinder, or slave cylinder. I'd like a second opinion or a little more info on this before I actually try anything since money is too tight for trial and error.
#4
i pooped a squirrel
Join Date: Nov 2009
Location: Ravaging shitholes
Posts: 9,307
Likes: 0
Received 0 Likes
on
0 Posts
Re: 95 Civic clutch issue
Csc is a cheap fix, have someone get in the car and press the clutch in while you watch the slave cylinder to see if its functioning properly.
#5
Registered Member
Thread Starter
Join Date: Aug 2011
Location: Chesapeake
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
Re: 95 Civic clutch issue
By loose, I mean there is no resistance on it at all. I think that it's not engaging at all until I press it at least halfway down and I'm not sure that it fully engages at times even when it's pressed all the way down.
Thread
Thread Starter
Forum
Replies
Last Post
Stea1thy
Engine / Exhaust / Drivetrain
2
09-25-2009 09:14 AM