1995 lt1/4l60e swap into 1991 buick roadmaster
#1
Registered Member
Thread Starter
Join Date: Jan 2004
Location: va beach
Posts: 1,315
Likes: 0
Received 0 Likes
on
0 Posts
1995 lt1/4l60e swap into 1991 buick roadmaster
the roadmaster currently has a 305 auto. has anyone done this swap or does anyone have any input as to what issues i might run into? i would like to keep my digital climate control if possible.
#2
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1995 lt1/4l60e swap into 1991 buick roadmaster
Make sure to align the rudder and to properly match the propeller to the engine output power range.
Seriously though... It has the steering response of a boat, wallows around like a boat, and is the size of a boat. It must be a boat.
Seriously though... It has the steering response of a boat, wallows around like a boat, and is the size of a boat. It must be a boat.
Last edited by Fabrik8; 12-22-2011 at 03:20 PM.
#3
Re: 1995 lt1/4l60e swap into 1991 buick roadmaster
That's not helpful in the tech section Sir! No bashing!
#4
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
#6
Registered Member
Thread Starter
Join Date: Jan 2004
Location: va beach
Posts: 1,315
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1995 lt1/4l60e swap into 1991 buick roadmaster
aww man...id forgotten about the shenanigans around this place.. the car is a bit of a boat but i like it that way. did i mention its a wagon. as for 26" wheels,thats a no go as the car will be bagged on 20's and the glasspacks wont fix the head gasket,shitty fuel economy,lack of power, and generally shitty engine thats in there to start with,thus the swap. i already have the lt1 and trans.
what im looking for is input on the wiring and if i will need to notch a cross-member,shorten the driveshaft,etc... yo fabrik..as for a prop..do you have a good one you could donate to the cause?
what im looking for is input on the wiring and if i will need to notch a cross-member,shorten the driveshaft,etc... yo fabrik..as for a prop..do you have a good one you could donate to the cause?
Thread
Thread Starter
Forum
Replies
Last Post