****auto to manual swap help*****
11-02-2007, 07:19 PM
#1
D15b1>k20a
Thread Starter
Join Date: May 2007
Location: richmond
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
****auto to manual swap help*****
ok im swappin a da from auto to manual..got the tranny in.. but just need a clutch cable is there anything else electrical or any other issues that i might have.. let me know..thanks for ur help
11-02-2007, 07:31 PM
#2
Registered Member
Join Date: Apr 2006
Location: near charlottesville
Posts: 1,051
Likes: 0
Received 0 Likes
on
0 Posts
Re: ****auto to manual swap help*****
have to tie a couple of the wires together at the auto shifter plug, two big wires if i remember correctly. Have to hardwire backup lights. Drill hole for clutch cable we used a wood boring bit.
11-03-2007, 08:18 AM
#3
D15b1>k20a
Thread Starter
Join Date: May 2007
Location: richmond
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
11-03-2007, 03:55 PM
#5
Registered Member
Join Date: Sep 2006
Posts: 2,169
Likes: 0
Received 0 Likes
on
0 Posts
Re: ****auto to manual swap help*****
make sure when u splice the shifter wires together u dont do it on the harness side. cut the plug off the shifter so that u can always plug one back in(not that u would want to)
11-04-2007, 05:27 AM
#6
Registered Member
Join Date: Oct 2007
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
Re: ****auto to manual swap help*****
change ecu to keep light off drilling that hole is a pain in the ass drill a couple of holes after you mount the shifter use bolts and nuts and if memory serves me correct you will have to grind the mount to make it slide in the body good luck it only took a few hours when I did mine changing the pedals and everything
11-09-2007, 11:01 AM
#8
not a noob
Join Date: Dec 2002
Posts: 899
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post