1998 S10 street/strip 500hp supercharged 327
Thread Starter
DMC
Joined: Dec 2010
Posts: 57
Likes: 0
From: chesapeake va
1998 S10 street/strip 500hp supercharged 327
Name: Mccaw
Location: Chesapeake, va
Means of contact: call/text 757-448-8187
Price: $8,000obo
Description: Ive got a 1998 chevy s10 pickup thats drag ready but yet still does great on the street. It is street legal and minus the no cats and the hood will pass va inspection. Ive had it awhile and really want to build a drift car so dont wanna see this beautiful setup that runs perfect sit any longer. trades-fc3s rx7 turbo II or any rx7 will be considered.
Now the mods
Engine:
8k miles on the whole setup
305 sbc bored to 4.0 in with 327 rods crank and pistons
aluminum heads with comp nitrous cams
hardned push rods
roller lifters
2.020 intake and 1.600 exhaust
screw in studs and guide plates
headers to full 3 inch exhaust dumped over axle with hushpower mufflers(not loud enough to get anymore attention from the cops)
chrome valve covers polish to a perfect mirror
weiand supercharger on 10 psi
holley fuel pump
full msd ignition with rev limiter box
holley carb
twin electric fans(keep it at perfect temp never overheated)
Trans:
corvette servos etc...
manual valve body
built 700R4
B&M ratchet shifter
Suspension and Chassis:
10 bolt rear end
3.73 gears(runs 2k RPMs at 60 and gets decent mileage believe it or not!)
mini spool
lowered 3 inches with trac bars and subframe connectors
typical drag tire setup 10 wide proxes in the back and skinnies up front
american racing drag rims
Body & other stuff:
body is in good condition nice white paint with minor scratches and dents
interior is 8/10 black on black
boost gauge on column and large tach with shift light all work with stock lights
no lights on dash except battery light which is typical chevy thing
12k hids
7 inch cowl hood painted to match truck
tonneau cover also painted to match
Bad:
crack across windsheild(does not touch sides so shouldnt be an issue)
This truck is ready for the strip and has no problem spinning the tires at 50mph. It leaks NOTHING! The swap was done with patience and done right. The ac compressor is removed but everything else is still there. The stock abs and everything else still functions as should. Speedometer is dead on. I have the stock hood and also have a decent set of slicks for it on stock rims. The price is obo but no lowballs or joyrides unless you have cash in hand. If you know anything about these swaps it can be a pain and the motor itself in parts alone totals over 10k. text for more pics ill be posting more this week
Pictures: [ATTACH=CONFIG]137098[/ATTACH][ATTACH=CONFIG]137099[/ATTACH]
Location: Chesapeake, va
Means of contact: call/text 757-448-8187
Price: $8,000obo
Description: Ive got a 1998 chevy s10 pickup thats drag ready but yet still does great on the street. It is street legal and minus the no cats and the hood will pass va inspection. Ive had it awhile and really want to build a drift car so dont wanna see this beautiful setup that runs perfect sit any longer. trades-fc3s rx7 turbo II or any rx7 will be considered.
Now the mods
Engine:
8k miles on the whole setup
305 sbc bored to 4.0 in with 327 rods crank and pistons
aluminum heads with comp nitrous cams
hardned push rods
roller lifters
2.020 intake and 1.600 exhaust
screw in studs and guide plates
headers to full 3 inch exhaust dumped over axle with hushpower mufflers(not loud enough to get anymore attention from the cops)
chrome valve covers polish to a perfect mirror
weiand supercharger on 10 psi
holley fuel pump
full msd ignition with rev limiter box
holley carb
twin electric fans(keep it at perfect temp never overheated)
Trans:
corvette servos etc...
manual valve body
built 700R4
B&M ratchet shifter
Suspension and Chassis:
10 bolt rear end
3.73 gears(runs 2k RPMs at 60 and gets decent mileage believe it or not!)
mini spool
lowered 3 inches with trac bars and subframe connectors
typical drag tire setup 10 wide proxes in the back and skinnies up front
american racing drag rims
Body & other stuff:
body is in good condition nice white paint with minor scratches and dents
interior is 8/10 black on black
boost gauge on column and large tach with shift light all work with stock lights
no lights on dash except battery light which is typical chevy thing
12k hids
7 inch cowl hood painted to match truck
tonneau cover also painted to match
Bad:
crack across windsheild(does not touch sides so shouldnt be an issue)
This truck is ready for the strip and has no problem spinning the tires at 50mph. It leaks NOTHING! The swap was done with patience and done right. The ac compressor is removed but everything else is still there. The stock abs and everything else still functions as should. Speedometer is dead on. I have the stock hood and also have a decent set of slicks for it on stock rims. The price is obo but no lowballs or joyrides unless you have cash in hand. If you know anything about these swaps it can be a pain and the motor itself in parts alone totals over 10k. text for more pics ill be posting more this week
Pictures: [ATTACH=CONFIG]137098[/ATTACH][ATTACH=CONFIG]137099[/ATTACH]
Last edited by Dulemc; May 20, 2012 at 12:28 PM.
Thread Starter
DMC
Joined: Dec 2010
Posts: 57
Likes: 0
From: chesapeake va
144 pro street series I believe will double check in am. No sheets but tuned on 93 pump gas only puts down approx 500- 550 HP. Never taken to track! Want somebody who can put it to its true uses to get it I can't stand watching it sit in my front yard any longer...
Thread Starter
DMC
Joined: Dec 2010
Posts: 57
Likes: 0
From: chesapeake va
Re: 1998 S10 street/strip 500hp supercharged 327
looking for a drift car before race season kicks in this is the fastest street legal s10 ive seen or heard of in the area pm or text me some offers
