Built b16 head, built bottomend, gsr trans, mounts!!!!!
Thread Starter
Registered Member
Joined: Aug 2004
Posts: 4,374
Likes: 0
From: woodbridge
Built b16 head, built bottomend, gsr trans, mounts!!!!!
Josh
Woodbridge
Pm or text 703 398 4804 or 703 398 5867
1. Built B16 head has inline pro springs, retainers,valves, jun cams, mild port and polish, inline pro fuel rail, 550 injectors, head is tapped for ls/vtec
SOLD
2. Built B18b bottomend- Cp Pistons 12.5:1 with B16 head. Eagle small bolt rods,acl bearings,Clean cyclinder walls, spun rod bearing -700 obo
3. Arp headstuds (ls/vtec)-SOLD!!!!
4.Gsr trans, small crack where fill bolt is on case (jb welded)- SOLD ( no grinds, or pop outs)
5. EG or Dc Hasport solid mounts. The tranny and rear mount are solid hasport mounts, driver mount is solid but unsure of brand. asking 250 obo
Bought this swap for close to 4000$ at tax time but it came with a b16 tranny with kaaz lsd and stage 4 clutch(sold that 2 days ago), I spun a rod bearing 3 weeks ago and pulled this to put in a single cam. I am interested in buying a h22 swap but at the same time would just like to make some of my money back. I am taking best offers.
If the head or block sell, for an additional 200$ I will throw in the ecu that is tuned on hondata s100. This swap was pulled out of a crx that consistently ran 12.3's in the quarter.
Woodbridge
Pm or text 703 398 4804 or 703 398 5867
1. Built B16 head has inline pro springs, retainers,valves, jun cams, mild port and polish, inline pro fuel rail, 550 injectors, head is tapped for ls/vtec
SOLD
2. Built B18b bottomend- Cp Pistons 12.5:1 with B16 head. Eagle small bolt rods,acl bearings,Clean cyclinder walls, spun rod bearing -700 obo
3. Arp headstuds (ls/vtec)-SOLD!!!!
4.Gsr trans, small crack where fill bolt is on case (jb welded)- SOLD ( no grinds, or pop outs)
5. EG or Dc Hasport solid mounts. The tranny and rear mount are solid hasport mounts, driver mount is solid but unsure of brand. asking 250 obo
Bought this swap for close to 4000$ at tax time but it came with a b16 tranny with kaaz lsd and stage 4 clutch(sold that 2 days ago), I spun a rod bearing 3 weeks ago and pulled this to put in a single cam. I am interested in buying a h22 swap but at the same time would just like to make some of my money back. I am taking best offers.
If the head or block sell, for an additional 200$ I will throw in the ecu that is tuned on hondata s100. This swap was pulled out of a crx that consistently ran 12.3's in the quarter.
Last edited by team703; Aug 12, 2010 at 05:30 AM.
Thread Starter
Registered Member
Joined: Aug 2004
Posts: 4,374
Likes: 0
From: woodbridge
Re: Built b16 head, built bottomend, gsr trans, mounts!!!!!
Not parting out. Bump Need 350 quick. will sell tranny for 350 until saturday!!!!! I work in fredericksburg if anyone wants it to meet up. Cannot drop prices on motor
