Im just writing on here to see whats the best B-series setup to put in my 90 acura integra?

I was thinkin of doin b20 turbo, but then i want to do b20/vtec turbo, or just a nice LS turbo.

But i dont know, just need help of whats best all round performance.

Thanks!!

 

b20 turbo bigger bang for your buck

 

b20/v-t would be nice if the block was sleeved then it would run great...cylinder walls too thin

 

I'd either go with a nice b20 boosted setup, or an LS boost setups. Both motors are good with boost, I don't know about the vtec add in, I'd probably leave then vtec out if you wanna go boost. Also, are you planning on building these motors at all?

 

yea i plan on building the engine like i was goin to go all motor so it can with stand the boost, im still new to what parts i need to get and all that stuff, just be awsome to learn everything and at the end feel good for what i built. At first i was goin to go LS supercharged to be different but i totally like turbos sounds amazing.

 

f22b1

 

b16a is the most reliable engine out there

 

umm any b-series engine would honestly do the trick in a DA but just so you know vtec and turbo (not a great mix) if your starting from scratch i would go with the b-20 non-vtec and boost it youll be walking cars all day

 

ight thanks

 

b20/ls boost would be prime!

forged pistons/rods, ecu(to tune), injectors, fuel rail, maybe better axles and prob a full out gasket/belts/tune up change etc

fuck vtec if you are gonna boost. youll just be spinning tires like mad

make sure your suspension and tires are in good shape before doing anything crazy. stabilize the car and then build