Sold thanks for the inquiries!! Please close this thread

 

bump

 

you sure its a y7? looks like a z6 and its a ex so it would make sense for that motor to be in it.

 

it says D16Y7 on the bottom end, and i didn't see any VTEC solenoid so i'm just assuming it's a Y7 head, that and when the P28 was in there it was throwing a code for VTEC spool valve, with no solenoid i just switched to a P06 and no more CEL

 

oh ok,look at the stamp on the front of the head and it will tell u..but glws good price

 

yea it says D16Y7, good lookin out though!

 

does it run?

 

x2?

 

yea it runs fine, normal honda clicking, the only thing that i have found so far that is not right is the temperature gauge. i know hondas typically run below the half way line but this one runs a little above the half way line on the temp gauge, but once it hits that operating temperature it stays there, haven't had any problems with it over heating. also it has a surge sometimes, comes and goes, don't know if something just needs to be cleaned or a new iacv?

 

bump