Built LS
Thread Starter
Registered Member
Joined: May 2006
Posts: 675
Likes: 0
From: va beach
Built LS
SOLD CLOSE THREAD
I have a b18a1 block it has SRP type R pistons perfect for an all motor ls/vtec setup....all u need would be gsr or b16 oil and water pumps....pistons are lightly used less then 1000 miles...bearings are fresh 500obo with this ill through in a new ls/vtec head gasket never fired on...Block also includes harness and alternator with unortodock pulleys....I bought the block from someone off of here. The block was bare beside the pistons and crank. The block is AS IS since i have never run it.
B18b1 bare block comes with pistons and rods just not assembled...was rebuilt so has fresh bearings...sleves are good no scratces etc...will not included oil and water pump also need coolent pipe 100 obo
A b series t bracket 50obo
I have a b18a1 block it has SRP type R pistons perfect for an all motor ls/vtec setup....all u need would be gsr or b16 oil and water pumps....pistons are lightly used less then 1000 miles...bearings are fresh 500obo with this ill through in a new ls/vtec head gasket never fired on...Block also includes harness and alternator with unortodock pulleys....I bought the block from someone off of here. The block was bare beside the pistons and crank. The block is AS IS since i have never run it.
B18b1 bare block comes with pistons and rods just not assembled...was rebuilt so has fresh bearings...sleves are good no scratces etc...will not included oil and water pump also need coolent pipe 100 obo
A b series t bracket 50obo
Last edited by ls/vtec hatch; Aug 18, 2007 at 06:18 AM.
