it's not as expensive or difficult as you think.

 

abacus?

 

its nice to see that you are being extremely helpful in answering his question.

 

if he really wanted info, he could pm me. but, by, the response after my post he doesn't look too interested.

 

But, in case he is interested,

the sleeving process (including machining, sleeves, pistons, rods) was only $2750.

 

You must have had quite a bit more done than just sleeving, in general sleeving usually costs ~1K (for most 4 cylinder blocks anyway).

Golden Eagle (no idea on quality, just have heard of a few people using them) usually has a 1.5-2 week turn around time, but you can get it expressed in under a week if you wanna pay for it.

 

hell yeah!!! call and ask for chuck

 

abacus rocks they just take awhile

 

I hoped they used some lube for you, cause you got fucked.

 

ignorance at it's ugliest form. it is an incredible deal considering these are the prices on pistons and rods. So you do the math. Don't forget, this isn't yours mom's honda either.