99CivicHatchSi

Engine:
1995 B18C1 w/ 98 Gsr tranny(built by BBJ from abacus)

Bottom End:
84mm Darton M.I.D Sleeves (done at abacus racing)
84mm Endyn Forged Pistons 9.5:1
Eagle Rods
Integra Type R Water Pump
Integra Type R Oil Pump
Integra Gsr transmission
Clutch Specialty 6 Puck Clutch
ACL Rod bearings

Head:
ARP headstuds
Skunk2 Type R Intake manifold
Portflow Dual Valvesprings
Portflow Titanium Retainers
Supertech Valves
Cometic 84mm Head Gasket
Integra Type R Vtec solenoid
00 Honda Civic Si Distributor
Precision 780cc injectors (will include rc 550cc injectors)
Msd 6A ignition
Poly-urethane Motor Mount Inserts
STR Fuel Rail
8mm Ngk Spark Plug Wires
Aeromotive Fuel Pressure Regulator
Fuel Pressure Gauge

I will also throw in both axles and the halfshaft..

swap has less than 2k miles on it.. has never been really opened up.. its a good strong motor that can also be used for a good all motor set up.. all you really need to do is change the pistons to high compression pistons..

I WILL NOT PART OUT

i will throw in a 2000 civic si DOHC VTEC valve cover that has the cam gear section cut out..

i can also throw in p28 ecu with a Hondata s200b with all the options for some extra cash

asking price is $4200 obo..

ultra spikey

will you part out the rod bearings? I just need 2

99CivicHatchSi

haha jon your an ass.. TTT

G2 LS-Vtec

Let me get your distributor/alternator

99CivicHatchSi

no i cant do that cj.. TTT

69vette

PM me a price on just the shortblock if your willing to part it from everything else. Do you have any compression or leakdown numbers for the engine?

v1chrgd

Would you take 3500Cash

99CivicHatchSi

before it was taken out.. i did a compression test.. and it was 200 across the board.. it was taken out of my EK.. at the end of nov/begining of december.. because i sold the ek.. to help pay for bills.. and for school.. the motor is sitting on a pallet in my garage also..

99CivicHatchSi

3500 is a little low.. but i also gave you a call and no answer..

99CivicHatchSi

TTT