Sabotage10

Does anyone know where I can find the right bolt length/size I am supposed to use to bolt my wranglers manual tranny to the motor? I recently picked up a wrangler that someone half-assed together and the bolts are either missing or they are being held on by one or two threads of a bolt because they are way short. I have looked in wrangler manuals and such and can't find anything. I know one option is to go buy a few different sizes and figure it out that way but it would just be easier to know what I need. Also, does anyone know of an easier way to remove the clutch master cylinder without having to drop the motor and tranny?

ChevyMudtruck

take one and go to your local hardware store and get some a little longer . ..

Sabotage10

That's what I just ended up doing. Any help with the master cylinder removal?

ChevyMudtruck

not a clue never worked on one

Hooch

depending on year master cylinder can be a real whore. the slave cylinder at the trans is a cake walk though only 2 bolts.

the master however can be a pain because if you have a tj and you break the clutch line between the 2 while removing them get ready to get pissed real quik. the actual removal itself im not to sure about but it should be self explanitory once looking at it...few bolts hear and there pull and replace....1-2-3. BTW the haynes manual will not show you how to do this!!! FIND A CHILTON or go to EASTCOAST4WD.NET its a mainly VA jeep forum. sign up and ask them they know most all the good stuff

'napa, advanced, dealer, no1 carries it and if you do break it dealer will sell u a whole unit that covers master to slave and line however needs an adapting bracket for the setup they sell you. problem being...they no longer make the bracket