Narrow springer front end, forged Ironhead Wiseco piston kit, 18x5.5 solid VROD wheel
01-27-2014, 06:36 PM
#1
static air
Thread Starter
Join Date: Jan 2006
Location: In the office
Posts: 1,088
Likes: 0
Received 0 Likes
on
0 Posts
Narrow springer front end, forged Ironhead Wiseco piston kit, 18x5.5 solid VROD wheel
Name: Doug
Location: Chesapeake
Means of contact: This is a dumb question
$500 obo - Have an old springer with a set of long chrome legs and a set of shorter raw finish legs (shown) that I machined out of 1022. Have other pictures of the longer legs available upon request.
Specs:
Top tree to axle about 43" with the chrome legs and 33" with the raw legs.
7/8" Stem
About 5 1/4" between the legs
Not looking to part out any of the pieces. Buyer pays shipping/paypal fees if not a local pickup.
$200 - Have some Wiseco 0.0030 over forged Harley Ironhead pistons with rings brand new in the box, 10:1 compression.
$200 obo - 18x5.5 solid wheel with a good 185/55-18 Dunlop tire on it. Buyer pays shipping if not a local pickup.
Bearings in there right now are 1" ID but will need to be replaced. If you need a smaller ID size you can always just throw your size bearing in there to accept a smaller axle.
Location: Chesapeake
Means of contact: This is a dumb question
$500 obo - Have an old springer with a set of long chrome legs and a set of shorter raw finish legs (shown) that I machined out of 1022. Have other pictures of the longer legs available upon request.
Specs:
Top tree to axle about 43" with the chrome legs and 33" with the raw legs.
7/8" Stem
About 5 1/4" between the legs
Not looking to part out any of the pieces. Buyer pays shipping/paypal fees if not a local pickup.
$200 - Have some Wiseco 0.0030 over forged Harley Ironhead pistons with rings brand new in the box, 10:1 compression.
$200 obo - 18x5.5 solid wheel with a good 185/55-18 Dunlop tire on it. Buyer pays shipping if not a local pickup.
Bearings in there right now are 1" ID but will need to be replaced. If you need a smaller ID size you can always just throw your size bearing in there to accept a smaller axle.
Thread
Thread Starter
Forum
Replies
Last Post
02type-sk20
Engine / Exhaust / Drivetrain
1
08-04-2011 06:13 PM