93 EG hatch Vtec
#1
Registered member
Thread Starter
Join Date: Sep 2012
Location: The County, VA
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
93 EG hatch Vtec
Name: drew
Location: hampton roads
Means of contact: 778.7983.(757)
Price: $2000 obo
Car has 1/14 inspection sticker!!!
not pictured.
Call or text for new pics that are not on thread.
Car Has D15B7 with fully rebuilt motor (OE) style! New clutch,flywheel, and rebuilt tranny. The motor below (pics) is the same now just took vtec head off and bought a b7 head then got it machined, washed and 3 angle valve job and I have recipes!!
Head will have to be put on by you and moor needs a re-time and new timing belt since I cut old belt to loosen crank bolt
Car needs to be towed cans head is not mated with block yet
front tires are 14 and rear is 13 cuase i put NEW x2 everything on front
-struts&springs
-lower control arms
-tie rod ends
-upper ball joints to camber arms
-both axles
Have 2 new rear stfu and springs that are not on car yet are in trunk!
and the most important both front Spindle/HUb assembles w/ slotted roters and calipers and pads purchased from JSH motors!
thats why i want 1500 otherwise id do 1k.. see 4th to last picture to see the small cancer spot on the car thats the only damage to the chassie/frame(:
MOTOR IS NOT BLOWN OR DAMAGE JUST NEEDS VAVLE COVER/HEAD GASKETS
Pictures:
Location: hampton roads
Means of contact: 778.7983.(757)
Price: $2000 obo
Car has 1/14 inspection sticker!!!
not pictured.
Call or text for new pics that are not on thread.
Car Has D15B7 with fully rebuilt motor (OE) style! New clutch,flywheel, and rebuilt tranny. The motor below (pics) is the same now just took vtec head off and bought a b7 head then got it machined, washed and 3 angle valve job and I have recipes!!
Head will have to be put on by you and moor needs a re-time and new timing belt since I cut old belt to loosen crank bolt
Car needs to be towed cans head is not mated with block yet
front tires are 14 and rear is 13 cuase i put NEW x2 everything on front
-struts&springs
-lower control arms
-tie rod ends
-upper ball joints to camber arms
-both axles
Have 2 new rear stfu and springs that are not on car yet are in trunk!
and the most important both front Spindle/HUb assembles w/ slotted roters and calipers and pads purchased from JSH motors!
thats why i want 1500 otherwise id do 1k.. see 4th to last picture to see the small cancer spot on the car thats the only damage to the chassie/frame(:
MOTOR IS NOT BLOWN OR DAMAGE JUST NEEDS VAVLE COVER/HEAD GASKETS
Pictures:
Last edited by ROyaLwCheeze; 03-06-2013 at 02:13 PM.
Thread
Thread Starter
Forum
Replies
Last Post