Semi Built LS Vtec
#1
Registered member
Thread Starter
Join Date: Oct 2008
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Semi Built LS Vtec
Name: Moe
Location: Roanoke Va
Call Or text: 549-293-5894
Like it says i have a semi built ls vtec for sell. I jus got married and have a 6 month old to worry about. I dont have the time anymore to put into this build.
Block: 91 ls block that was freshly honed and cleaned
stock ls crank with fresh polish
ls rods with type r p73 pistons
gsr water pump 22t
gsr timing belt
new oil pump
new piston rings and main and rod bearings
all new gaskets and seals
arp head studs
Head: 99 B16a2 head
stock valvetrain with type r cams, still have b16 cams too
already plugged for ls vtec
also have the complete golden eagle setup for ls vtec
Transmission: B16 cable tranny. NO grinds or pop outs.
And i also have everything needed to swap into a ef.
hasport motor mounts
ecu tuned on monotech with 2step and lower vtec, also have stock b16 ecu
obd0 to obd1 harness
both axels with half shaft
shift linkage with short throw shifter.
Will sell whole swap for 2000 firm and thats less than i have in it.
Also i have a 91 crx si rolling shell that is primered sitting on blue rota jmags with nuespeed lowering springs, aftermarket blue lower control arms. It is pretty much all stock other than that. Selling for 500 with steelies or 1000 with jmags. Or you could jus get everything for 2800 firm.
Thanks for lookin. I can get pics upon request by email.
Location: Roanoke Va
Call Or text: 549-293-5894
Like it says i have a semi built ls vtec for sell. I jus got married and have a 6 month old to worry about. I dont have the time anymore to put into this build.
Block: 91 ls block that was freshly honed and cleaned
stock ls crank with fresh polish
ls rods with type r p73 pistons
gsr water pump 22t
gsr timing belt
new oil pump
new piston rings and main and rod bearings
all new gaskets and seals
arp head studs
Head: 99 B16a2 head
stock valvetrain with type r cams, still have b16 cams too
already plugged for ls vtec
also have the complete golden eagle setup for ls vtec
Transmission: B16 cable tranny. NO grinds or pop outs.
And i also have everything needed to swap into a ef.
hasport motor mounts
ecu tuned on monotech with 2step and lower vtec, also have stock b16 ecu
obd0 to obd1 harness
both axels with half shaft
shift linkage with short throw shifter.
Will sell whole swap for 2000 firm and thats less than i have in it.
Also i have a 91 crx si rolling shell that is primered sitting on blue rota jmags with nuespeed lowering springs, aftermarket blue lower control arms. It is pretty much all stock other than that. Selling for 500 with steelies or 1000 with jmags. Or you could jus get everything for 2800 firm.
Thanks for lookin. I can get pics upon request by email.
Thread
Thread Starter
Forum
Replies
Last Post
vtec2.0
Engine / Exhaust / Drivetrain
17
11-01-2009 12:39 PM
LSD_Moe_Lester
Engine / Exhaust / Drivetrain
60
10-02-2009 10:58 AM