MPFI SWAP FOR CIVIC/CRX
12-17-2008, 10:45 PM
#1
やくざに成りたい
Thread Starter
Join Date: Nov 2004
Location: virginia beach
Posts: 2,174
Likes: 0
Received 0 Likes
on
0 Posts
MPFI SWAP FOR CIVIC/CRX
SOLD!!!!!!!!!!!!!!!!!!!!!!!!!!!
Take it all now engine and everything for $100 obo I just need it gone asap or its going to garbage I need the space in my storage!!
Hey guys just seeing if anyone is interested in a complete MPFI swap for a civic/crx. comes with complete intake manifold with throttle body, all sensors intact, fuel rail and injectors, Injector clips, resistor box, Si distributor, pm6 ECU, candy cane coolant hose (a lot of people forget this!).
All u need is...
- a shorter throttle cable (i may have one i have to check, you can use the long one it will just have to go around the engine.)
- Si engine harness for some plugs (ebay, pick n pull)
im asking $150
more info upon intrest, thanks
UPDATE for $215 I'll throw in a running full d15 swap with everything attached.
info bout the engine
it ran good when i had it in, has about 130k on it. i pulled it over a year ago and it has been sitting. it needs a vss for the transmission, u can get one from the junk yard, only problem it really had was that when the engine was warm after driving for a while and you park, when you come back to start it, it would run for a minute and die, but if you held the gas for a lil bit then it would be fine again. Never left me stranded though. but all in all it was a strong running motor. i think it smoked a little but what 130k engine doesnt. If u have anymore questions let me know.
it also needs a few vacuum hoses, and a nut for
the valve cover, and a stud for the exhaust manifold, these u can get from any
honda in a junk yard for free.
Edit/Delete Message
Take it all now engine and everything for $100 obo I just need it gone asap or its going to garbage I need the space in my storage!!
Hey guys just seeing if anyone is interested in a complete MPFI swap for a civic/crx. comes with complete intake manifold with throttle body, all sensors intact, fuel rail and injectors, Injector clips, resistor box, Si distributor, pm6 ECU, candy cane coolant hose (a lot of people forget this!).
All u need is...
- a shorter throttle cable (i may have one i have to check, you can use the long one it will just have to go around the engine.)
- Si engine harness for some plugs (ebay, pick n pull)
im asking $150
more info upon intrest, thanks
UPDATE for $215 I'll throw in a running full d15 swap with everything attached.
info bout the engine
it ran good when i had it in, has about 130k on it. i pulled it over a year ago and it has been sitting. it needs a vss for the transmission, u can get one from the junk yard, only problem it really had was that when the engine was warm after driving for a while and you park, when you come back to start it, it would run for a minute and die, but if you held the gas for a lil bit then it would be fine again. Never left me stranded though. but all in all it was a strong running motor. i think it smoked a little but what 130k engine doesnt. If u have anymore questions let me know.
it also needs a few vacuum hoses, and a nut for
the valve cover, and a stud for the exhaust manifold, these u can get from any
honda in a junk yard for free.
Edit/Delete Message
Last edited by atmdc; 02-09-2009 at 08:34 PM. Reason: price change
Thread
Thread Starter
Forum
Replies
Last Post