Garrett GT2860rs turbo with T3 flange
09-21-2013, 08:56 AM
#1
Registered Member
Thread Starter
Join Date: Sep 2013
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Garrett GT2860rs turbo with T3 flange
Genuine Garrett GT2860rs (T3 flange) dual ball bearing
Price: $450 picked up or $485 shipped
Miles: <5000
Location: Oxford, NC 27565
PM or email me: thang_cu35@yahoo.com
This turbo has a brand new center housing put in Oct 2012 and has seen maybe 5000 miles since (still has receipt of new CHRA $830 from Turbosdirect). It has zero to minimal shaft play. No leak or smoke. It ran at 10-11 psi with air filter so no chip in any of the wheels.
The turbine housing was professionally ceramic coated and is a T3 flange with 3" v-band discharge.The compressor housing is ceramic clear coated. The turbo will come with 4AN restricted oil feed with and 36" braided oil feed line. Oil drain is 8AN. Both water ports have 6AN fittings. No wastegate included.
Price: $450 picked up or $485 shipped
Miles: <5000
Location: Oxford, NC 27565
PM or email me: thang_cu35@yahoo.com
This turbo has a brand new center housing put in Oct 2012 and has seen maybe 5000 miles since (still has receipt of new CHRA $830 from Turbosdirect). It has zero to minimal shaft play. No leak or smoke. It ran at 10-11 psi with air filter so no chip in any of the wheels.
The turbine housing was professionally ceramic coated and is a T3 flange with 3" v-band discharge.The compressor housing is ceramic clear coated. The turbo will come with 4AN restricted oil feed with and 36" braided oil feed line. Oil drain is 8AN. Both water ports have 6AN fittings. No wastegate included.
Thread
Thread Starter
Forum
Replies
Last Post
mike420crx
Engine / Exhaust / Drivetrain
5
09-16-2010 06:23 AM