Fully built k24/k20
#1
Fully built k24/k20
Name: Forrest Grauling
Location: Baltimore MD
Means of contact: text or call 443-686-1995
Price: $ 7000 OBO
Description: I have a fully built k24A8 with a fully built k20z3 head
Block was bored 1MM over hot tanked
Cranked was micro polished
Cp 12.5:1 swan tech coated pistons
Brian crower lightweight all motor sportsmans rods
Acl race bearings
Rsx type s oil pump and windage tray
K20a2 aluminum oil pan
Minor port and polish job on the head
Super tech bronze valve guides (all 16 done)
Super tech titanium retainers
Super tech seats
Super tech valve seals
Oem keepers
Kelford 179-B cams
All new timing chain guides and bolts
New oil pump with tensioner and balance shaft
OEM type R wrinkle red valve cover
also have a nos nitrous kit with full bottle all lines and solenoids
Ignore
K20 k24 built all motor nitrous Honda Acura eg ek hatch sedan coupe
Pictures:
ILOVEPENIS -- If this line is still here it means you probably didn't fill out the required information correctly and a mod will be locking your thread shortly. You should probably delete it.
Location: Baltimore MD
Means of contact: text or call 443-686-1995
Price: $ 7000 OBO
Description: I have a fully built k24A8 with a fully built k20z3 head
Block was bored 1MM over hot tanked
Cranked was micro polished
Cp 12.5:1 swan tech coated pistons
Brian crower lightweight all motor sportsmans rods
Acl race bearings
Rsx type s oil pump and windage tray
K20a2 aluminum oil pan
Minor port and polish job on the head
Super tech bronze valve guides (all 16 done)
Super tech titanium retainers
Super tech seats
Super tech valve seals
Oem keepers
Kelford 179-B cams
All new timing chain guides and bolts
New oil pump with tensioner and balance shaft
OEM type R wrinkle red valve cover
also have a nos nitrous kit with full bottle all lines and solenoids
Ignore
K20 k24 built all motor nitrous Honda Acura eg ek hatch sedan coupe
Pictures:
ILOVEPENIS -- If this line is still here it means you probably didn't fill out the required information correctly and a mod will be locking your thread shortly. You should probably delete it.
Thread
Thread Starter
Forum
Replies
Last Post