Fully built GSR head
#1
Registered Member
Thread Starter
Join Date: Jun 2011
Location: 434
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
Fully built GSR head
Name: Kyle
Location: C'ville
Means of contact: (434)-249-6902
Price: $600obo will trade for wheels or gsr tranny. NO junk
Description: First off, please keep all negative comments off of my thread! If you don't like the price, press back!
I would only like to trade for wheels of equal value or a b16 or gsr transmission with no grinds, pop outs, or any issues.
I have for sale a built GSR head. It has less than 3,000 miles on it since the machine shop. The work was done at J and F Motors
Head is a milled 95 Gsr fully built
-Head was hot tanked and stripped down
-Mild port job
-GSR cams
-AEM cam gears
-Supertech dual valve springs and titanium retainers
-Ferrea stainless steel dish valves
-Bronze valve guides and valve seals
-Skunk 2 1st gen intake manifold
-400cc injectors
-Itr throttle body
Every engine seal has been replaced cam, crank, rear main, ect.
Pictures: [ATTACH=CONFIG]162606[/ATTACH][ATTACH=CONFIG]162608[/ATTACH][ATTACH=CONFIG]162610[/ATTACH][ATTACH=CONFIG]162611[/ATTACH]
ILOVEPENIS -- If this line is still here it means you probably didn't fill out the required information correctly and a mod will be locking your thread shortly. You should probably delete it.
Location: C'ville
Means of contact: (434)-249-6902
Price: $600obo will trade for wheels or gsr tranny. NO junk
Description: First off, please keep all negative comments off of my thread! If you don't like the price, press back!
I would only like to trade for wheels of equal value or a b16 or gsr transmission with no grinds, pop outs, or any issues.
I have for sale a built GSR head. It has less than 3,000 miles on it since the machine shop. The work was done at J and F Motors
Head is a milled 95 Gsr fully built
-Head was hot tanked and stripped down
-Mild port job
-GSR cams
-AEM cam gears
-Supertech dual valve springs and titanium retainers
-Ferrea stainless steel dish valves
-Bronze valve guides and valve seals
-Skunk 2 1st gen intake manifold
-400cc injectors
-Itr throttle body
Every engine seal has been replaced cam, crank, rear main, ect.
Pictures: [ATTACH=CONFIG]162606[/ATTACH][ATTACH=CONFIG]162608[/ATTACH][ATTACH=CONFIG]162610[/ATTACH][ATTACH=CONFIG]162611[/ATTACH]
ILOVEPENIS -- If this line is still here it means you probably didn't fill out the required information correctly and a mod will be locking your thread shortly. You should probably delete it.
Last edited by ex2000; 03-21-2013 at 12:24 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Tegin804
Engine / Exhaust / Drivetrain
6
01-18-2012 11:25 AM
Rickb295
Engine / Exhaust / Drivetrain
31
09-02-2010 07:44 PM
1ns0mniac
Engine / Exhaust / Drivetrain
23
07-09-2009 06:14 PM