Darton MID 84mm sleeves honda/acura
#7
Re: Darton MID 84mm sleeves honda/acura
Your block is set up on a cnc and it bores out the entire stock sleeve, so nothing is left. Then these are pressed into your block. It can be costly for this to be done, unless you know of a place that can do it cheaper other than darton.
Thread
Thread Starter
Forum
Replies
Last Post
fullCircling
Engine / Exhaust / Drivetrain
14
08-09-2011 05:29 PM
breakfastking33
Engine / Exhaust / Drivetrain
8
04-17-2010 12:29 PM