Built K24/K20, Type R tranny
#1
Registered Member
Thread Starter
Join Date: Apr 2007
Posts: 248
Likes: 0
Received 0 Likes
on
0 Posts
Built K24/K20, Type R tranny
SOLD!!.I have a built K24/K20 motor, type S engine harness, with 03 K20 type R LSD tranny. This motor has about 2k miles and runs really strong, no problems, tranny shifts smooth with no problems. This is a complete longblock, tranny and engine harness. Made 252WHP 198WTQ. Located in harrisonburg area. PM with any questions. SOLD!!!!
Motor
-All new gaskets from Honda
-K24a4 block
-ACL bearing
-Blueprint H-beam rods
-Wiseco 87.5mm bore, 11:1 compression
-type s oil pump
-blueprint head studs
-RC 550cc injectors with pigtail clips
-Golden eagle fuel rail
-EP3 idle pulley
-Type s head
-Skunk 2 springs and retainers
-Skunk 2 valves
-RBC intake manifold
-Brian crower stage 2 all-motor cams
-hondata IM gasket
-Type s engine harness and charging harness
-K20 Type R LSD tranny
-K20 type r flywheel
-ACT 6 pad with heavy duty pressure plate
Motor
-All new gaskets from Honda
-K24a4 block
-ACL bearing
-Blueprint H-beam rods
-Wiseco 87.5mm bore, 11:1 compression
-type s oil pump
-blueprint head studs
-RC 550cc injectors with pigtail clips
-Golden eagle fuel rail
-EP3 idle pulley
-Type s head
-Skunk 2 springs and retainers
-Skunk 2 valves
-RBC intake manifold
-Brian crower stage 2 all-motor cams
-hondata IM gasket
-Type s engine harness and charging harness
-K20 Type R LSD tranny
-K20 type r flywheel
-ACT 6 pad with heavy duty pressure plate
Last edited by typeswerx; 07-12-2009 at 05:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
vtec2.0
Engine / Exhaust / Drivetrain
22
02-20-2009 08:20 PM