b16a2, CTR, RINGS
#1
Registered member
Thread Starter
Join Date: Jan 2009
Location: 540!
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
b16a2, CTR, RINGS
I have a b16a2 block fresh from the machine shop, has been bored to 81.25mm to fit the CTR pistons
B16B CTR pistons on b16a rods (have been machined to fit)
also have a full set of rings that are still in the packaging to fit the CTR pistons
I have a good little amount of money tied up in parts and machine work alone, willing to trade what i have for a complete d16z6 or as close to complete as i can get. condition doesnt matter as long as it doesnt require to much machine work.
I have changed my mind and now want to build a single cam so I am giving up on the b series. I will get more pics of everthing asap. below is a pic of a CTR piston incase you dont know what they look like
B16B CTR pistons on b16a rods (have been machined to fit)
also have a full set of rings that are still in the packaging to fit the CTR pistons
I have a good little amount of money tied up in parts and machine work alone, willing to trade what i have for a complete d16z6 or as close to complete as i can get. condition doesnt matter as long as it doesnt require to much machine work.
I have changed my mind and now want to build a single cam so I am giving up on the b series. I will get more pics of everthing asap. below is a pic of a CTR piston incase you dont know what they look like
Last edited by Ginger_Ninja; 05-13-2010 at 06:38 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ExoticGunplay
Parts ARCHIVE
16
12-08-2007 04:47 PM