b16 swap into 91 ef semi built
11-19-2010, 05:54 AM
#1
Registered Member
Thread Starter
Join Date: Feb 2008
Location: Woodbridge
Posts: 747
Likes: 0
Received 0 Likes
on
0 Posts
b16 swap into 91 ef semi built
OFFER ANYTHING NEED GONE ASAP!!!! found car I want someone buy this
-The engine was originally built by Hybrid Garage of Fredericksburg. Since then, I have replaced the head gasket with a cometic three-layer gasket and re-installed the head using ARP head studs.
-The transmission is a JDM SiR cable trans. No grinds, or pop outs
-The head is put together with InlinePro dual valve springs and titanium retainers. The valves are brand new Honda OEM valves, and I just had the head resurfaced before re-installing, as well as having had all the valve seals and guides replaced with OEM Honda parts.
-The bottom end is built using CTR replica 12:1 compression high-rise pistons, with shot-peened rods, ACL race bearings, and a knife-edged and re-balanced crank. All internals can be validated by Hybrid Garage.
-It currently has Buddy Club cam gears bolted on to GSR cams. With a slightly more aggressive cam, this motor will make serious power.
Comes with p71 tuned on crome
50-60K miles on it and comes with mounts, wire harness, ecu, tranny
1500 obo
-The engine was originally built by Hybrid Garage of Fredericksburg. Since then, I have replaced the head gasket with a cometic three-layer gasket and re-installed the head using ARP head studs.
-The transmission is a JDM SiR cable trans. No grinds, or pop outs
-The head is put together with InlinePro dual valve springs and titanium retainers. The valves are brand new Honda OEM valves, and I just had the head resurfaced before re-installing, as well as having had all the valve seals and guides replaced with OEM Honda parts.
-The bottom end is built using CTR replica 12:1 compression high-rise pistons, with shot-peened rods, ACL race bearings, and a knife-edged and re-balanced crank. All internals can be validated by Hybrid Garage.
-It currently has Buddy Club cam gears bolted on to GSR cams. With a slightly more aggressive cam, this motor will make serious power.
Comes with p71 tuned on crome
50-60K miles on it and comes with mounts, wire harness, ecu, tranny
1500 obo
Last edited by steggun revned; 12-19-2010 at 08:09 AM.
