question about coolant change...
#1
Registered Member
Thread Starter
Join Date: May 2004
Location: lake ridge / nova
Posts: 973
Likes: 0
Received 0 Likes
on
0 Posts
question about coolant change...
switching out watter wetter and putting coolant in on the new bike and i've always just flushed the system...this manual says to flush the system but when removing the drain bolt on the water pump to also remove a drain bolt on the cylinder. I've never done this before...does that sound normal to anyone else? thanks for any info
#2
Registered Member
Join Date: May 2003
Location: Richmond
Posts: 4,707
Likes: 0
Received 0 Likes
on
0 Posts
Re: question about coolant change...
I guess theres a drain bolt on the cylinder too. Is the RR or the 1000? Either way you should be fine just removing the drain bolt on the water pump housing, also maybe undo any of the coolant hoses you can easily get to and dump some more out that way.
#3
Registered Member
Thread Starter
Join Date: May 2004
Location: lake ridge / nova
Posts: 973
Likes: 0
Received 0 Likes
on
0 Posts
Re: question about coolant change...
it's the 600rr. yeah, i'm just gonna do that. i can easily see the cylinder drain bolt behind the header but i've never seen that done before . don't know. i just don't want any water left in there when it's starting to get cold...that's all i'm worried about
Last edited by seanazzy; 09-25-2007 at 02:46 AM.
Thread
Thread Starter
Forum
Replies
Last Post