PAWESOME

Bike: 1989 Ninja zx1000

I just got in my new clutch (fibers & steels)
I went to install them and I did everything to the T like I always have with any of my bikes.
EXCEPT
My Uncle decided to pressurize the clutch lines while the basket or anything was connected...
Now the piston that pushes the basket outward to release the clutches is stuck and i cannot complete assembly of the clutch

I bled all the fluid out the system and the piston still won't retract, it's stuck in the position as if the clutch was disengaged.

If anyone can help via phone or stop by... please call immediately for more information

Will pay for answers/help.

Thanks

757 927 9639 (Portsmouth/Chesapeake)

PAWESOME

I took the slave cylinder off and pulled the connecting rod out so now the clutch is installed etc... but now the clutch won't bleed...

rollingstock

geeezz. sounds like u got air in the lines.. but u did alot of work for a easy job..


sorry.. cant really help u without seeing the bike. since i really dont know what all u have done

EMCracing

hay its shane i can fix it hit me up if you want

PAWESOME

Thanks shane. I got it to bleed but now when on interstate and it gets hot the slave likes to stick out 1/8 to 3/16 inches causing my shit to slip. WTF