Low RPM vibration when engine is under load
06-02-2014, 05:57 AM
#1
TwoWheels YearRound
Thread Starter
Join Date: Mar 2010
Location: Inside the Beltway
Posts: 12,705
Likes: 0
Received 0 Likes
on
0 Posts
Low RPM vibration when engine is under load
- 2013 Z1000
- All stock other than M4 slip-ons; no other performance modifiers
- Almost 13k on the odometer
- Still has original spark plugs
- It is a very faint pulsing vibration, feels like it is come from down low on the bike, but not sure
- Everything clears up above around 3000-3500 rpm
- It doesn't seem to do it with the clutch pulled in.
- It started the morning after a riding in a rain storm the night before
EDIT:
- Mostly occurs below 2000 rpm
- I can feel it mostly through the footpegs
- Happens in 1st and 2nd but only below 2000-2500 rpm (I haven't tested higher gears yet)
- Chain is lubed weekly
Any ideas? Thanks ahead of time.
Last edited by Southwade; 06-02-2014 at 08:47 AM.
06-03-2014, 03:57 AM
#5
Registered member
Join Date: Dec 2010
Posts: 442
Likes: 0
Received 0 Likes
on
0 Posts
Re: Low RPM vibration when engine is under load
i know u said chain is lubed weekly but is it adjusted properly? may have too much play in it and its hitting the sliders on the swingarm, or ur sliders could be eaten up at the ends so the sound is chain rubbing the alloy swing arm vs. the plastic slider.
also check passenger pegs, they seem to get lose and rattle against the bracket, so u hear it when the bike isnt all revved up but still happens when u rev it more u just dont notice it.
check the rearset bolts and the one the hold the peg to the rear set.
any chance u can catch it on video?
also great miles for a 2013. a naked 2013 too, impressive. i need to get me one of these z1000s one day. good luck, hope u figure it out.
oh, sell it and get a motard
also check passenger pegs, they seem to get lose and rattle against the bracket, so u hear it when the bike isnt all revved up but still happens when u rev it more u just dont notice it.
check the rearset bolts and the one the hold the peg to the rear set.
any chance u can catch it on video?
also great miles for a 2013. a naked 2013 too, impressive. i need to get me one of these z1000s one day. good luck, hope u figure it out.
oh, sell it and get a motard
06-03-2014, 06:19 AM
#6
TwoWheels YearRound
Thread Starter
Join Date: Mar 2010
Location: Inside the Beltway
Posts: 12,705
Likes: 0
Received 0 Likes
on
0 Posts
Re: Low RPM vibration when engine is under load
fxd
The Zed is a surprising bike, it's secretly a sport-touring bike hopped-up on speed and red bull, but marketed as a measly streetfighter. It's sister bike is the Ninja 1000, which is one of the best sport-touring bikes on the market. The Zed shares it's engine but with a more aggressive sprocket set-up.
I keep the chain near spec: 1 inch + or - a third. It's currently at the looser end of the range, but still in spec.
Also, I filled up with a fresh tank of Shell gas at my normally used gas station yesterday and today the symptoms have subsided greatly.
Hopefully this was all just a bad tank of gas.
[fingers crossed]
The Zed is a surprising bike, it's secretly a sport-touring bike hopped-up on speed and red bull, but marketed as a measly streetfighter. It's sister bike is the Ninja 1000, which is one of the best sport-touring bikes on the market. The Zed shares it's engine but with a more aggressive sprocket set-up.
I keep the chain near spec: 1 inch + or - a third. It's currently at the looser end of the range, but still in spec.
Also, I filled up with a fresh tank of Shell gas at my normally used gas station yesterday and today the symptoms have subsided greatly.
Hopefully this was all just a bad tank of gas.
[fingers crossed]
Last edited by Southwade; 06-03-2014 at 06:40 AM.
Thread
Thread Starter
Forum
Replies
Last Post