5.0 Guys.... Help Needed....
#1
Settled..
Thread Starter
Join Date: Nov 2002
Location: Richmond,VA
Posts: 1,350
Likes: 0
Received 0 Likes
on
0 Posts
5.0 Guys.... Help Needed....
Well I have messsed up another set of Roller Rocker arms. Come to find out my RR's are hitting my guideplates. Anyone know where I can get a good set of guide plates for Trick Flow High Port Heads? and can I reuse rocker arms that have been hitting them? The RR's have some wear marks on them.
Thanks for any help....
Thanks for any help....
#4
Settled..
Thread Starter
Join Date: Nov 2002
Location: Richmond,VA
Posts: 1,350
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by IWL BCNU
Where are the rockers hitting the guide plates? I can't think of anyway a properly set up set could hit. Is it on the end or the fulcrum?
Where are the rockers hitting the guide plates? I can't think of anyway a properly set up set could hit. Is it on the end or the fulcrum?
#5
Makes it sound like your push rods are to short to me. What kind of pattern do you have on the valve stems? Take a sharpie and mark the valve stem, turn the motor over and make sure it is staying pretty much centered.
Last edited by IWL BCNU; 09-25-2003 at 05:13 AM.
Thread
Thread Starter
Forum
Replies
Last Post